Precautions for safe use generators

Guangxi Star Technology Department Customer Service Engineer in check customer diesel generators are found, some of the problems are of customers in the process of operation of the generator and unintentionally do not regulate the operation result, these problems can be avoided, the diesel generating set in the work, must have the staff on duty, always pay attention to a series of failures to observe possible, pay particular attention to the change of important factors, water temperature, oil pressure, oil temperature, voltage and frequency etc.. Also note that the prepared enough diesel, in operation such as fuel interrupt, objectively create with a load of parking, the damage may lead to the generator excitation control system and related components. This suggested a room regulations and work processes, each of the steps and matters needing attention every day before starting to check them one by one, in order to avoid damage to the machine.

A, preparation before start

Each must check the diesel generator water tank and engine oil tank before starting to see the inside of the water tank, the cooling water or antifreeze whether meet the requirements of the boot, such as lack of to fill; pull out the oil dipstick check the lubricating oil is lacking, such as lack of added to the provisions of the "static full scale line". Then carefully check the other relevant parts are hidden fault, fault found to promptly eliminate, all ready to boot. Before starting the preparation work is very important, once the machine running after the discovery of these problems, bring inconvenience to the machine and work after operation.

Two, it is forbidden to start the diesel engine load

Diesel generator should pay attention to output air switch must be switched off before starting. Ordinary type generating set diesel engine start after 3-5 minutes of running at idle speed (700 RPM) in winter the temperature is low, idle time should be extended a few minutes. Start the engine should first observe the oil pressure is normal and there is no oil leakage, water leakage and other abnormal phenomena, (oil pressure under normal circumstances must be 0.2MPa or more) such as abnormal to immediately stop machine overhaul. If no abnormal phenomenon will speed diesel engine to raise to the rated speed of 1500 rpm, this generator display frequency 50HZ, voltage 400V, you can close the air output switch is put into use. Generator no-load operation does not allow for a long time. If long time no load operation can make the diesel engine fuel injection nozzle of diesel can not completely burn cause carbon deposition, resulting in valve, piston rings leak. The other is the automatic unit, you do not need to idle running, because automation units are generally equipped with water heater, so that the cylinder body of the diesel engine is always maintained at 45 DEG C, start the engine can be normal power transmission in 8-15 seconds.

Three, always watch the diesel generator running state

Diesel generating set at work, always pay attention to observe a series of fault may occur, with particular attention to the change of important factors of oil pressure, water temperature, oil temperature, voltage, frequency, etc.. Also note that the prepared enough diesel fuel in operation such as interrupt, objectively create with a load of parking, the damage may lead to the generator excitation control system and related components.

Four, it is strictly prohibited to load down

Every time before shutdown, must gradually cut off the load, generator output close air switch and then finally diesel engine deceleration to idle state run 3-5 minutes and then stop.

Operation five, in strict accordance with the safety operation procedure.

Safe operation of diesel generator set is a standard specification for the industry as a whole to the operation of diesel generator, is the operation of the machine the valuable experience of many professional summed up, so you can rest assured that in accordance with the operation process of the operation of the machine. The operation process to meet this article diesel generator safe operation process.

Six, if not understand, can call the company I phone 0771-3805033 4008333086 consulting related technical problems.